Help? Troubleshooting - Kenwood DNX5240BT Instruction Manual

Help?
Troubleshooting
Some functions of this unit may be disabled by
some settings made on this unit.
!
• Cannot set up the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
• Cannot set up the high pass filter.
Subwoofer is not set to On.
(page 56)
Preout is set to "Rear".
60)
The Dual zone function is enabled.
Control> (page 80)
!
Cannot set up the subwoofer phase.
Subwoofer is not set to On.
(page 56)
Low pass filter is set to Through.
Network Setup> (page 57)
!
• Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear
speakers.
The Dual zone function is disabled.
Control> (page 80)
!
Cannot play audio files.
"CD Read" of <System Setup> (page 60) is set
to "2".
!
Cannot Folder select.
The Scan play or Random play function is
enabled.
!
Cannot perform Repeat play.
The PBC function is enabled.
!
• Cannot set up the equalizer.
• Cannot set up the crossover network.
The Dual zone function is enabled.
Control> (page 80)
!
Cannot watch the source selected as AV-OUT
in the rear monitor.
A source control screen is displayed in front.
<AV lnterface Setup> (page 62)
"AV-OUT Graphic Output" of <AV Interface
Setup> is set to "Black".
90 DNX5240BT/DNX5240/DDX5024/DDX5054/DDX54R
☞
<Audio Setup>
☞
<System Setup> (page
☞
<Zone
☞
<Audio Setup>
☞
<Crossover
☞
<Zone
☞
<Zone
☞
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
?
The Touch Sensor Tone doesn't sound.
✔
The preout jack is being used.
☞
The Touch Sensor Tone can't be output from
the preout jack.
Tuner source
?
Radio reception is poor.
✔
The car antenna is not extended.
☞
Pull the antenna out all the way.
✔
The antenna control wire is not connected.
☞
Connect the wire correctly, referring to the
section on <INSTALLATION MANUAL>.
Disc source
?
The specified disc does not play, but another
one plays instead.
✔
The specified disc is quite dirty.
☞
Clean the disc.
✔
The disc is severely scratched.
☞
Try another disc instead.
Audio file source
?
The sound skips when an Audio file is being
played.
✔
The media is scratched or dirty.
☞
Clean the media, referring to the CD
cleaning of the section on <Handling discs>
(page 6).
✔
The recording condition is bad.
☞
Record the media again or use another
media.
Navigation
?
The touch panel control of the navigation
system does not work.
✔
Navigation software is not the latest version.
☞
Update the navigation software. For how to
update the software, refer to the instruction
manual of the navigation unit.