Download  Print this page

Kenwood CMOS-310 Instruction Manual page 10

Universal multi-view camera/universal rear view camera
Hide thumbs

Advertisement

Camera Setting (CMOS-310 only)
Overhead View Image Adjustment
(Up-and-Down Angle)
This item adjusts the vertical angle (inclination) of the
camera installation position.
1
Select "OVERHEAD VIEW IMAGE ADJUSTMENT
(Up-and-Down ANGLE)".
2
Press the + or – button of the switch unit so
that the lines indicating the vehicle width are
shown vertical.
Adjustment is possible by one step up and down. If the
adjustment is not possible in the currently available range,
change the camera position before retrying.
3
After completing the adjustment, press the
view button.
4
Select [Next].
Advances to "WIDE VIEW GUIDELINE
ADJUSTMENT (Size)".
10
|
CMOS-310/CMOS-210
For Guideline Adjustment
• The subsequent adjustments adjust the sizes, lengths and positions
of the guidelines displayed in the wide view and overhead view.
By default, three guidelines shown below (green, yellow and red)
are displayed assuming that the camera installation height is 80
cm (2.62 feet) and that the distance between the left and right
lines of the parking space is 2.2 meters (7.22 feet). Adjusting the
wide view or overhead guidelines alters the interval between the
corresponding guidelines. As the interval between each set of
guidelines varies depending on the camera installation height,
check the actual settings after all of the following adjustments are
completed.
• Once the interval between guidelines has been adjusted according
to your parking space, the displayed guidelines do no longer
indicate the width of the vehicle. Note that the sizes of parking
space are greatly variable and confirm the actual size of each
parking space before attempting to park in it.
• The orange line indicates the position of the overhead view (area
on the near side of the orange line) and of the wide view (area
beyond the orange line) in the PinP view (page 14). When the
orange line displayed in the wide view exceeds the parking line,
slow down the vehicle and move until the red line (parking
position) by checking it in the overhead view.
• The red line is used to indicate the parking position and can set it
independently from other guide lines.
2.2 m (7.22 feet)
Green
Orange
Yellow
0.5 m
Red
(1.64 feet)
2.7 m
(8.86 feet)

Advertisement

Table of Contents
loading

  Related Manuals for Kenwood CMOS-310

This manual is also suitable for:

Cmos-210