Background Operations; T Ime - Out T Imer (Tot); S Ignal S Trength I Ndicator; C Ompander - Kenwood NEXEDGE NX-700 Instruction Manual

Vhf/uhf digital transceiver
Hide thumbs Also See for NEXEDGE NX-700:
Table of Contents

Advertisement

Your dealer can activate a variety of transceiver functions to perform without any
additional operation on your part.
T
-
T
(ToT)
ime
ouT
imer
The Time-out Timer is used to prevent you from using a channel for an extended
duration. If you continuously transmit for a preset time, the transceiver will stop
transmitting and an alert tone will sound. Release the microphone PTT switch.
S
S
i
ignAl
TrengTh
ndicATor
The signal strength indicator displays the strength of received calls.
Strong
No icon appears when no signal is available.
flashes when out of range (NXDN Trunking only).
c
ompAnder
If programmed by your dealer for a channel, the compander will remove
excessive noise from transmitted signals, to provide higher clarity of signals.
b
c
l
uSy
hAnnel
ockouT
On Conventional channels, if BCL is set up by your dealer, you will be unable to
transmit if the channel is already in use. Use a different channel or wait until the
channel becomes free.
If BCL Override has been programmed, you can transmit over the current signal:
1 Press and hold the PTT switch.
• If the channel is already in use, a warning tone will sound.
2 Quickly release and then press the PTT switch again.
3 Speak into the microphone as you would during a normal call.
c
c
h
onTrol
hAnnel
On digital Trunking channels, the transceiver automatically searches for a control
channel.
• While searching for a control channel, the antenna icon will flash and no signals can be
received.

pTT id

PTT ID is the transceiver unique ID code which is sent each time the PTT switch
is pressed and/or released.
Note: PTT ID can be made only in analog operation.
20

BACKGROUND OPERATIONS

Sufficient
(bcl)
unT
Weak
Very weak

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nexedge nx-800

Table of Contents