Mft/3: Setting Up And Assembly; Step 1: Setting Up; Step 2: Trim Splinter Guard - Festool MFT/3 Instruction Manual

MFT/3:
Setting up and assembly
Accessory attachments can be secured at
different points on the multifunction table
to enable different working positions.
In the standard working position, the user
stands along one side of the bench [Fig. 2].
In these operating instructions, this side of
the bench is referred to as the "front".

Step 1: Setting up

Take the table out of the box. Screw on
the knobs [2-3] until the stop is reached.
Unfold the foldaway legs and tighten the
knobs on the joints to secure. Turn the end
cap [2-1] on the right to adjust the length
of the leg and compensate for an uneven
fl oor surface.
NOTE: The corner feet [2-2] are fi tted
with rubber caps so that the bench stands
securely when the legs are folded away.
2-3
2-2
2
2-1
3-2

Step 2: Trim splinter guard

3-1
Now you are ready to set up the guide rail
system. The fi rst thing to do is to trim the
splinter guard [3-4] of the guide rail using
your Festool plunge-cut saw.
Place your saw on top of the guide rail
3-4
and tune it to the track on the rail using a
screwdriver [3-3] to loosen or tighten the
front and back set screws so that there
3-3
is no play between the sole plate of the
3
saw and he raised portion of the guide
rail. However, make sure that the saw still
glides smoothly on top of the guide rail.
5