Oil Filter Change - Honda Marine BF115A Owner's Manual

Oil Filter Change

1. Drain the engine oil, and reinstall
the drain bolt, washer, and drain
bolt cover (see Engine Oil Change
on p. 70 ).
2. Tilt the outboard motor, and place
a suitable container below the oil
drain guide to catch the used oil.
3. Use a suitable tool to remove the
oil filter, and thoroughly drain the
filter into the used oil container.
SERVICING YOUR OUTBOARD MOTOR
USE A SUITABLE TOOL
OIL FILTER
OIL DRAIN GUIDE
RUBBER SEAL
4. Clean the oil filter mounting base,
and coat the rubber seal of the new
oil filter with clean engine oil.
Use only a Honda Genuine oil
f ilter or a f ilter of equivalent
quality specif ied f or your model.
Using the wrong f ilter, or a non-
Honda f ilter which is not of
equivalent quality, may cause
engine damage.
5. Screw on the new filter by hand
until it contacts the engine, then
use a suitable tool to tighten the
filter an additional 7/8 turn.
OIL FILTER TIGHTENING
TORQUE:
9 lbf·ft (12 N·m , 1.2 kgf·m)
71