9. CLEANING
AND FLUSMING
Thoroughly
clean and flush the out-
board motor with fresh water after
operation in dirty or salty water.
Flushing with the Water Hose Joint
(optional equipment)
Do not run the engine dunng this
flushing procedure. For safety,remove
the emergency stop switch clip, so the
engine cannot be started while you
are standing near the propeller.
1. Remove the hose joint cap
2. Install the water hose joint (optional
equipment) in the water joint
3. Connect a water hose to the water
hose joint (optional equipment), and
turn on the water supply.
104