Searching An Input Signal; Selecting An Aspect Ratio - Hitachi CP-X200 User Manual

Selecting an input signal (continued)
1.
Press VIDEO button on the remote control.
Each time you press the button, the projector switches its input
port as below.
COMPONENT(Y, Cb/Pb, Cr/Pr)  S-VIDEO  VIDEO
● If VIDEO button is pushed to switch from a signal from
COMPUTER IN1 or 2 port, when TURN ON is selected for AUTO
SEARCH item in OPTION menu
COMPONENT port first. If no input is detected at the port, the projector will
check the other port in above order.

Searching an input signal

1.
Press SEARCH button on the remote control.
The projector will start to check its input ports in order to
find any input signals.
When an input is found, the projector will stop searching and
display the image. If no signal is found, the projector will return to
the state selected before the operation.
COMPUTER IN 1  COMPUTER IN 2
VIDEO

Selecting an aspect ratio

1.
Press ASPECT button on the remote control.
Each time you press the button, the projector switches the
mode for aspect ratio in turn.
 For a computer signal
NORMAL  4:3  6:9  SMALL
 For a video signal, s-video signal or component video
signal
4:3  6:9  4:9  SMALL
 For no signal
4:3 (fixed)
● ASPECT button does not work when no proper signal is inputted.
● NORMAL mode keeps the original aspect ratio setting.
S-VIDEO COMPONENT (Y, Cb/Pb, Cr/Pr)
 
, the projector will check
(40)
Operating
VIDEO
COMPUTER
VIDEO SEARCH
BLANK
ASPECT AUTO
MAGNIFY
HOME PAGE UP VOLUME
ON
END PAGE DOWN MUTE
OFF
FREEZE MY BUTTON KEYSTONE
1 2
POSITION MENU
ENTER
RESET
ESC
SEARCH
COMPUTER
VIDEO SEARCH
BLANK
ASPECT AUTO
MAGNIFY
HOME PAGE UP VOLUME
ON
PAGE DOWN MUTE
END
OFF
FREEZE MY BUTTON KEYSTONE
1 2
POSITION MENU
ENTER
ESC RESET
ASPECT
COMPUTER
VIDEO SEARCH
ASPECT AUTO BLANK
MAGNIFY
HOME PAGE UP VOLUME
ON
PAGE DOWN MUTE
END
OFF
FREEZE
MY BUTTON KEYSTONE
1 2
POSITION MENU
ENTER
ESC RESET
7