Preparatory Operation; Operation - Fujitsu ART90 Series Operating Manual

PREPARATORY OPERATION

Set the current day and time
1
CLOCK ADJUST
Press the timer mode (CLOCK
ADJUST) button for 2 seconds
or more. The time display on
the remote controller will flash.
3

OPERATION

Instructions relating to heating are applicable only to "HEAT & COOL MODEL " (Reverse Cycle).
To start/stop operation
To set the operation mode
G Operation mode setting
G Room temperature setting
Lower Raise
G Fan speed setting
3
9365350034_P1-P15
2
DAY
DAY OFF
SU
Press the set time buttons to set the current time.
Press repeatedly to adjust the current time in 1-
minute increments. Press and hold to adjust the
current time in 10-minute increments.
SU MO TU WE TH FR SA
ex. Monday 10:00
Press the start/stop button.
Operation lamp
Air conditioner ON: Lit brightly
Air conditioner OFF: Not lit
Press the master control button to set the operation mode.
If DRY is selected, the fan speed will be set to AUTO.
AUTO COOL
Press the set temperature buttons to set the room temperature.
Temperature setting range
AUTO ............................................... 18 to 30 °C
COOL/DRY ....................................... 18 to 30 °C
HEAT ................................................ 16 to 30 °C
Follow the instruction in the "CUTTING THE JUMPER LINE" section of the IN-
STALLATION INSTRUCTION SHEET and change the Fan speed display.
3
Press the DAY button and select the current day.
A appears around the selected day.
MO TU WE TH
4
Press again to end.
DRY FAN HEAT
4/25/05, 1:48 PM
FR SA
CLOCK ADJUST