Attaching The Center System To A Wall - Yamaha YAS-71 Owner's Manual

• Attaching the center system to a wall
Installing the center system using the keyholes
You can attach the center system to a wall using commercially available screws (#8, Diameter: 7.5 mm or more
5116" or more)).
When installing the center system on a wall, all installation work must be performed by a qualified
contractor or dealer. The customer must never attempt to perform this installation work. Improper or
inadequate installation could cause the center system to fall, resulting in personal injury.
1
Attach the supplied mounting template on a
wall and mark the holes of the mounting
template.
2
or thumbtacks
[ _ Mark ]_
Remove the mounting template and then
install the commercially available screws at
the marks.
Diameter: .... _ 5
4 to 6 mm (3/i6" t0 1/4") J
To install the cables above the center system,refer to the right
column.
3
Hang the center system on the screws using
the keyholes on the back of the center
system.
f
Installing the cables above the center system
To pass the cables upward, you need to attach the
spacers to make room on the back of the center system.
In step 2 of the left column;
2-a: Attach the supplied spacers to the rear panel of the
center system using the supplied double-sided
tapes. You can choose either the side A or the side
B.
A: For narrow space
B: For wide space
Double-sided
tape
Attach Attach
2-b: Remove the mounting template and then install
the commercially available screws at the marks.
22 to 24 mm 34 to 36 mm
(718" to 15/16")
( 1-5/16" to 1-7116")
//
9En