Cycle Selection Chart; Canceling A Cycle; Changing A Cycle Or Setting; Adding Items During A Cycle - Whirlpool DU805DWGB1 Use & Care Manual

For Series 400, 800, 801,805, 810 and 811:
Turn the Cycle Control knob to the desired cycle.
For Series 840:
Press the desired cycle. Turn the Cycle Control knob to the
desired cycle. If the door is latched, you will hear the cycles start
and stop as the Cycle Control knob passes each cycle mark. This
is normal and does not hurt the dishwasher. If you prefer, you can
set the Cycle Control knob with the door unlatched.
NOTE: Normal Wash, Light Wash and Rinse Only all share the
same cycle button.
For Series 850 and 890:
Press the desired cycle. Turn the Cycle Control knob to the
desired cycle. If the door is latched, you will hear the cycles start
and stop as the Cycle Control knob passes each cycle mark. This
is normal and does not hurt the dishwasher. If you prefer, you can
set the Cycle Control knob with the door unlatched.
To use Rinse Only, press Normal or Light and turn the Cycle
Control knob to RINSE ONLY.
A "0" shows what steps are in each cycle. Your model may have
some or all or the cycles shown.
Water usage is shown in U.5. gallons/liters.
Cycle time includes dry time.
Use this cycle for hard-to-
clean, heavily-soiled pots,
pans, casseroles, and
regular tableware.
Use both
detergent
dispenser
sections.
Wash
Rinse Rinse Main Rinse
Wash
Final Dry
Rinse
Time Water
(min) Usage
(gal/L)
98 8.6/32.7
Use this cycle for loads
with heavy rood soil.
Use both
detergent
dispenser
sections.
Wash
Rinse Rinse Main Rinse
Wash
Final Dry
Rinse
Time Water
(min) Usage
(gal/L)
98 8.6/32.7
Use this cycle for pre- Use
rinsed or lightly soiled covered
loads, detergent
dispenser
section.
Wash Rinse Rinse Main Rinse Final Dry Time Water
Wash Rinse (min) Usage
(gal/L)
85 5.7/21.8
Use this cycle for rinsing
dishes, glasses, and
silverware that will not be
washed right away.
Do not use
detergent
with this
cycle.
Wash Rinse Rinse Main Rinse Final Dry Time Water
Wash Rinse (min) Usage
(gal/L)
20 2.9/10.9
a CV{I*'
You can cancel a cycle at any time.
1. Turn the Cycle Control knob slowly clockwise until you hear
water draining. Let the dishwasher drain completely.
2. Open the door.
3. Turn the Cycle Control knob to OFE
/
(On some models)
If your dishwasher has more than one wash cycle, you can
change a cycle anytime during a cycle.
1. Lift the door latch to stop the cycle.
2. Turn the Cycle Control knob clockwise.
3. Check the detergent dispensers. They must be filled properly
for the new cycle.
NOTE: Turning the Cycle Control knob can cause the covered
Detergent Dispenser section to open and release the
detergent. Check the covered section if the cycle uses
detergent in both sections.
4. Close the door firmly until it latches. The dishwasher starts a
new cycle.
Wash
Use this cycle for loads
with normal amounts of
rood soil. (The energy-
usage label is based on
this cycle.)
Use both
detergent
dispenser
sections.
Rinse Rinse Main Rinse Final Dry Time
Wash Rinse (min)
90
Water
Usage
(gal/L)
7.2/27.2
(On some models)
You can add an item anytime before the main wash starts, or the
Cycle Control knob reaches Light Wash.
1. Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.
2. Open the door and add the item.
3. Close the door, but do not latch it. Wait 30 seconds for the air
in the dishwasher to warm up. This reduces the amount of
moisture escaping from the vent when restarting a cycle.
4. Close the door firmly until it latches. The dishwasher resumes
the cycle.
13