Different sounds a re
coming from the
clothes v italizer.
Clothing i sdamp
This is normal.
Loaded 3 articles of clothing.
Higher room temperature and
humidity can increase drying time.
During the misting stage of a cycle, you will hear a spraying sound. During the drying stage
you will hear a low hum coming from the fan. In between stages is a dwell time in which a
pulsing sound from the fan may be heard.
Run the GENTLEDRY
cycle until clothes are dry. Three articles of clothing reduce
airflow, causing areas on some clothes to be slightly damp at the end of the cycle.
Run the GENTLEDRY
cycle for a few minutes.
Nozzle may be partially clogged.
See "Maintenance" section for clearing a clogged nozzle. Clean clothes according to
Water spots on
the care label on the article of clothing.
Cycle selection was incorrect.
Clean clothes according to care label on the article of clothing. Choose the
RegularCare setting to match the fabric in your load. See "Cycles" section for informa-
tion on running loads with different fabric types.
Clothing was touching the interior
Clean clothes according to care label on the article of clothing. Be sure Clothes
sides or doors.
Hangers are positioned in the notches on the hanger bar. If clothing is large or bulky,
reduce the number of clothes loaded in the clothes vitalizer.
Formula dripped off hanger bar or
Clean clothes according to the care label on the article of clothing. The spots should come
out with just the recommended cleaning method.
Weight clips fall off
Clothing was not fully inserted into
Be sure the clothing is fully inserted into the clip.
If you are going over a seam, make sure the seam lines up with the contoured area in
the middle of the clip's pad.
Formula residue on pads.
Rinse with warm water to remove formula residue.
Formula collects in
This is normal for some cycles.
There may be formula left over after the HeavyDuty cycle, Remove the basin cover and
the bottom of the
dry the basin with a clean towel.