Whirlpool ACM082PS7 Use & Care Manual page 11

Fan Speed
Set FAN SPEED to the desired setting. When the air conditioner
is operating at Low Cool, High Cool (on some models), Med Cool
(on some models) or Turbo Cool (on some models), the fan
circulates air continuously.
• Turbo Cool (on some models)--for maximum cooling
• High Cool (on some models)--for normal to maximum
cooling (depending on model)
• Med Cool (on some models)--for normal cooling
• Low Cool--for sleeping comfort
• Power Saver (on some models)--Fan run only when cooling
is needed.
• Fan Only--to move air continuously without cooling
Model I
Waitthree mip_tes
bef0relestarting ran
Power
Saver
Temperature
Turn the TEMPERATURE control to a mid-setting. Adjust the air
conditioner's performance by turning the Temperature control
clockwise for maximum cooling. For less cooling, turn the
TEMPERATURE control counterclockwise. Experiment to find the
setting that suits you best.
Cooler Warmer
1
3
4
Roll the wheel or use the tab, depending on model, to direct the
air right or left. Rotate the whole cartridge to direct air up, down
or straight ahead.
Model 2
Cool
Med
Cool
Fan
)nly
Low
Cool
A. Wheel
A
Model 3
High
Cool
Turbo
Cool
Fan
_nly
Low
Cool
High
Cod
A. Tab
A. Cartridge
When your air conditioner is operating normally, you may hear
sounds such as:
• Droplets of water hitting the condenser, causing a pinging or
clicking sound. The water droplets help cool the condenser.
• Air movement from the fan.
• Clicks from the thermostat cycle.
• Vibrations or noise due to poor wall or window construction.
• A high-pitched hum or pulsating noise caused by the modern
high-efficiency compressor cycling on and off.
11