Table of Contents
Advertisement
General Cleaning
The door is heavy. For
safe, temporary
storage, lay the door
flat with the inside of the door facing
down.
To Remove
and
Replace
Oven
Door
To Remove Oven Door:
I.
Open the door.
2.
Remove screws located on the inside of the oven door near the hinges A
(one on each side.)
3.
Close the door to the quarter-open
position. Grasp the door firmly on both
sides and lift up and off the hinges.
4.
To clean oven door, follow the instructions
provided
in the cleaning chart
under General Cleaning
Lift door strai ht off 2 door hinges
/
Pullupwith finger
Remo_e shield _ r¥
IIIIde. Pull up on left lever
while pushing down on
down with finger
Figure 1
Figure 2
To Replace Oven Door:
1.
Besurethe hinge arms arein the quarter-open
position. Be careful if pulling
the hinges open by hand. The hinges may snap back against the oven frame
and could pinch fingers.
2.
Hold the door at the sides near the top. Insert the hinge arms into slots at
the bottom
of the door.
3.
Hinge arms must go into the range slots evenly. The hinge arms should be
inserted into the bottom
corners of the door as far as they can go.
4.
If the door is not in linewith
the oven frame, remove it and repeat theabove
steps.
To Remove
and
Replace
Warmer
Drawer
(if equipped)
To Remove Warmer Drawer:
1.
_
Turn power off before removing the warmer drawer.
2.
Open the drawer to the fully opened position.
3.
On the right glide you will find a shield attached with a hex-head screw (see
figure 1). Using a 1/4" socket and ratchet remove the shield.
4.
Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever.
5.
Pull the drawer away from the range.
To Replace Warmer
Drawer:
1.
Replace shield on the right glide of the drawer body.
2.
Pull the bearing glides to the front
of the chassis glide (see figure 2).
3.
Align the glide on each side of the drawer with the glide slots on the range.
4.
Push the drawer into the range until levers "click" (approximately
2"). Pull
the drawer open again to seat bearing glides into position. If you do not
hear the levers "click"
or the bearing glides do not feel seated remove
the drawer
and repeat steps 2-4. This will minimize possible damage to
the bearing glides.
[FIVA'h__:t_II_[ell E lectrical Shock Hazard can occur and result in
serious injury
or death.
Disconnect
appliance
from electric
power before cleaning and servicing the warmer drawer.
19
Advertisement
Table of Contents
