Specifications; Cleaning The Cabinet; To Save A Tape Permanently; Cleaning The Tape Heads - Sony MHC-GX45 Operating Instructions Manual

Cleaning the cabinet
Clean the cabinet, panel and controls with a soft cloth
slightly moistened with mild detergent solution. DO not
use any type of abrasive pad, scouring powder or
solvent such as thinner, benzene or Mcohoh
To save a tape permanently
To prevent a tape |Yore being accidentally recorded
over, break of f the cassette tab from side A or B as
illustrated,
If you later wmlt to reuse the tape |br recording, cover
the broken tab with adhesive tape.
Before placing a cassette in the tape
deck
Take up any slack in the tape. Otherwise, the tape may
get entangled in the parts of the tape deck and become
damaged.
When using a tape longer than
SO minutes
The tape is very elastic. Do not change the tape
operations such as play, slop, and Past-winding
frequently. The tape may get entangled in the tape
deck.
Cleaning the tape heads
Clean the tape ]leads after every 10 hours of use. Be
sure to clean the tape heads be|bre you s_art an
important recording or al_er playing an old tape. Use a
separalely sold dry-type or wet4ype cleaning cassette.
For details, refer to the instructions of the cleaning
cassette.
DemagneUsing the tape heads
Denlagnetise the tape ]leads and the metal parts that
have contact with the tape after every 20 to 30 hours of
use with a separately sold demagnetising cassette. For
delails, refer to the instructions of the demagnetisti/g
cassette.
AUDIO POWER SPECIFICATIONS
(MHC-GX45/GX25 USA model only)
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
With 6 ohm loads, bofl_ channels driven, from
120 10,000 ttz: rated 120 watts per channel
minimum RMS power, wilh no more than 10%
total harmonic dislortion from 250 milliwatts 1o
rated output.
Amplifier section
North American models:
MHC-GX45
Front speaker
Continuous RMS power oulput (reference):
120 _ 120 watts (6 ohms al
I kHz, 10% THD)
Total harmonic distortion less than 0.07% (6 ohms at
I kltz, 60 W)
Sub woofer
Continuous RMS power output (reference):
120 waits (6 ohms at
60 l]z, 10% THD)
Total harmonic distortion less than 0.07% (6 ohms at
60 llz, 60 W)
MHC-GX35
Continuous RMS power output (reference):
120 _ 120 watts (h ohms al
I kHz, 10% THD)
Total harmonic distortion less than (h07% (6 ohms at
I kHz, 60 W)
MHC-GX25
Continuous RMS power output (reference):
120 _ 120 watts (h ohms al
I kHz, 10% THD)
Total harmonic distortion less than 0.07% (6 ohms at
I k!tz, 60 W)
30G8