Sony KP-61V45 Operating Instructions Manual page 41

You call program the supplied remote control to
operate a cable box or DBS receiver. Follow the
procedures below to set the manufacturer's code
number in the remote control.
DISPLAY*
=1_1
JUMP
TV/DBS*
CODE SET
0@_0
_CD
DBS/CABLE (POWER)
m DBS/CABLE
(FUNCTION)
m0 - 9 buttons
--ENTER
--GUIDE*
• 141_,1._1 _ *
--MENU*
-- CH +/-
r
* The TV/DBS, GUIDE, DISPLAY, t/,I,/,_l,#/(Z), and MENU
buttons can be used only with a DBS receiver.
1
Turn off the equipment you want to set up,
and press DBSICABLE (FUNCTION).
FUNCTION -
DBS/CABLE
2
Press the CODE SET, DBSICABLE (FUNCTION),
and 0 - 9 buttons to enter the
manufacturer's code number (see the chart
on the right column), then press ENTER. For
example, to program your remote control
to operate a Sony DBS receiver, press CODE
SET, DBS/CABLE (FUNCTION), 8, 0, 1, and
ENTER.
FUNCTION ENTER
CODE SET DBS/CABLE 'JI-
Press DBS/CABLE (POWER) to turn on the
cable box or DBS receiver.
DBSICABLE
rith_e cable control buttons
4 Use' box/DBS to
check if the code number works.
For example, to operate a cable box or DBS receiver,
you can use the DBS/CABLE (POWER), JUMP, CH
+/-, 0 - 9 and ENTER buttons.
Note
* If the cable box or DBS receiver does not have a certain
function, the corresponding button on this remote control will
not operate.
To operate the projection TV
Press TV (FUNCTION). Then use the projection TV
control buttons to control the projection TV.
For more details on operating the cable box or
DBS receiver
Refer to the operating instructions that come with the
equipment.
If the remote control doesn't work
• First, try repeating the setup procedures using the other codes
listed for your equipment.
Manufacturer code numbers (cable box)
Manufacturer
Hamlin/Regal
Jerrold/G. 1.
Oak
Panasonic
Pioneer
Scientific Atlanta
Tocom
Zenith
Code number
222,223, 224,225,226
201,202,203,204,205,206,207,208,
218
227,228,229
219,220,221
214,215
209,210,211
216,217
212,213
Manufacturer code numbers (DBS receiver)
Manufacturer Code number
Sony 801 (preset code for the supplied
remote control)
RCA 802
Notes
• If more than one code number is listed, try entering them one
by one until you come to the correct code for your equipment.
• If you enter a new code number, the code number you
previously entered at that setting is erased.
• In some rare cases, your equipment may use a code that is not
provided with this remote control and you may not be able to
operate your equipment with the supplied remote control. In
this case, use the equipment's own remote control unit.
• Whenever you remove the batteries -- to replace them, for
example -- if too much time is taken, the code numbers may
revert to the factory setting and must be reset.
Operations
I 41-EN