Sony Trinitron KV-1460R Operating Instructions Manual page 6

_F Setttng Up
Select one ot the three way_ to connect the TV to the antenna and/or
cable system. It is recommended to connect an outdoor antenna or a
cable TV system for better picture quality.
Connecting to outdoor antenna
Connect the antenna cable to the VHF-UHF antenna terminal. If the
antenna cable cannot be connected directly to the jack, follow one of the
diagrams below, depending on the type of cable you have.
Notes
• Do not use tools to attach the cable to the VHF/UHF terminal. Doing so may
damage the terminal.
• Most VHF/UHF combination antennas have a signal splitter. Remove the splitter
before attaching the appropriate connector.
• If the U/V mixer is used, snow and noise may appear in the picture when viewing
cable 'IV channels over 37.
[] (Rear of TV)
• VHF only
or
• VHF/UHF
[]
• VHF only
or
• UHF only
or
• VHF/UHF
• VHF
and
• UHF
/UH_I B 75-ohm coaxial cable
To attach an F-type connector, see "Attaching
an F-type connector to the antenna cable."
(Rear of TV)
Loosen
connect the leads, then
tighten.
Antenna connector (supplied
except for KV-MT2000/ST2050)
300-ohm twin lead cable
75-ohm coaxial cable
(Rear of TV) 4
_;;'_ _ EAC-66 UV mixner
300-ohm twin lead cable
6