Connecting A Vcr - Samsung LN52A550 User Manual

Connecting a VCR
Video Connection
These instructions assume that you have already connected your TV to an antenna or a cable TV system (according to the
instructions on pages 6-7). Skip step 1 if you have not yet connected to an antenna or a cable system.
1. Unplug the cable or
antenna from the back
of the TV.
1
Connect the cable or
antenna to the ANT IN
terminal on the back of
the VCR.
3, Connect an RF Cable
between the ANT OUT
terminal on the VCR
and theANT IN terminal
on the TV.
4, Connect a Video Cable
between the VIDEO
OUT jack on the
VCR and theAV IN 1
[Y/VIDEO] orAV IN 2
[VIDEO] jack on the TV.
5, ConnectAudio Cables
between the AUDIO
OUT jacks on the VCR
and theAV IN 1 (orAV
IN 2) [R-AUDIO-L] jacks
on the TV.
VCR Rear Panel
TV Rear Panel
If you have a "mono"
(non-stereo) VCR,
use a Y-connector
(not supplied) to
hook up to the right
and left audio input
jacks of the TV. If
your VCR is stereo,
you must connect
two cables.
TVSide Panel
Follow the instructions in "Viewing a VCR or Camcorder Tape" to view your VCR tape.
Each VCR has a different back panel configuration.
When connecting a VCR, match the color of the connection terminal to the cable.
When connecting toAV IN 1, the color of the AV IN 1 [Y/VIDEO] jack (Green) does not
match the color of the video cable (Yellow).
S-Video Connection
Your Samsung TV can be connected to an S-Video jack on a VCR. (This connection delivers a better picture as compared
to a standard VCR.)
1. To begin, follow steps
1-3 in the previous
section to connect the
antenna or cable to your
VCR and your TV.
2, Connect an S-Video
Cable between the
S-VIDEO OUT jack on
the VCR and the
AV IN 2 [S-VIDEO] jack
on the TV.
3. ConnectAudio Cables
between the AUDIO
OUT jacks on the VCR
and theAV IN 2
[R-AUDIO-L] jacks on
the TV.
VCR Rear Panel
"IV Rear Panel
TV Side Panel
An S-Video cable may be included with a VCR. (If not, check your local electronics store.)
Each VCR has a different back panel configuration.
When connecting a VCR, match the color of the connection terminal to the cable.