Connecting A Vcr - Samsung LT-P2045 Owner's Instructions Manual

BN6U-00633A-06Eng l.qxd.q b/12/04 6:31 PM Page_0
I
IN STALLATION
I
Connecting a VCR
These instructions assmne that you have already connected your TV to an antenna or a
cable TV system (according to the instructions on pages 6-9).
Skip step I if you have not yet connected to an antenna or a cable system.
1
Unplugthe cable or
antenna fromthe
back of the TV.
2
Connect the cable or
VCR Rear
Panel
amenna to the _ ""_0 . 'c:: ":_ _ )
ANTENNA IN terminal Incoming O_ "<®4) ®
/
Cable or L
on the back of the
Antenna
VCR.
3
Connect a coaxial
cable between the
ANTENNA OUT
terminal on the VCR
ane the amenna
terminal on the TV.
VCR Rear PaneU TV Rear Panel
A coaxial cable is usually included with a VCR. (Ii not, check your local electronics store).
Connect a set of L
audiocables L
between theAUDIO
OUT]acks on the
VCR and the AUDIO
jacks on the TV,
TV Rear PaneH
VCR Rear PaneU m .o,
If you have a "mono" (non-stereo) VCR, use the Y-connector (not supplied) to hook up
to the left and right audio input ,jacks of the TV.
If your VCR is stereo, you must connect two cables.
Connect a video
cable between the
VIDEO OUTjack on
the VCR an d the
VIDEO jack on the
TV,
F
TV Rear Panel
Folk)w the instructions in "Viewing a VCR or Camcorder Tape" to view your VCR tape.
_:Each external input source device has a ditTerent back panel coniiguration.
English- 1 0