Ematic TWIG User Manual page 13

b. Connecting to a network: Press "Wi-Fi settings" to enter into this menu, the system will find the WiFi
name automatically. Please refer to the example picture below, it has found several WiFi network names:
After selecting the network you would like to connect to, the system will either connect to the network or if
the network is secured and requires a security key to be entered, selecting it, will pop up a Connection
window, where you can input the correct security code and press "Connect".
The system will connect to the network automatically, and once connected will show a Status of
"Connected" You can see the network connection status by pressing the network name, see the figure
below:
c. IP address settings and connection: There are two setting methods to allow the IP address to be
set. Whether the IP Address is distributed automatically or not, is dependant on the Wi-Fi Router's
settings.
1. IP Address is assigned automatically：
By default this device is setup to be assigned an IP Address automatically.
If the wireless network you want to connect to, assigns the IP Address automatically, but the settings
have been changed to a Static IP Address, use the following procedure to change the settings. Press the
TWIG User's Manual 12