Advertisement
8
How to maintain your vacuum cleaner
Make sure vacuum cleaner is turned off and power cord is unplugged.
Maintain brush roll
Motor pulley can become hot with normal use.
Remove hair and threads from brush roll periodically. Do not remove end caps.
Check belt ZE090. Replace if worn, cut or out of shape.
Avoid touching the motor shaft when checking the brush roll or belt.
How to replace brush roll or belt.
1) Step on handle release to lower
handle flat onto floor (Fig.1).
2) Remove 4 screws from brush roll
cover (Fig.2).
3) Lift off brush roll cover (Fig.3).
4) Remove brush roll and belt. Thread
new belt around motor shaft and
brush roll (Fig.4).
5) Insert left end of brush roll first. Make
sure end cap fits into base. Pull right
side of brush roll to stretch belt and
insert right end cap into base (Fig.5).
Make sure it slides into position.
6) Rotate brush roll 2 turns to centre
belt.
7) Replace brush roll cover (Fig.3).
8) Replace 4 screws (Fig.6).
How to Clear a Blockage
Make sure the vacuum is turned off and the power cord is unplugged
Hose blockage
1) Remove hose from hose retainer.
Flex the hose to loosen any
blockage (Fig.1).
2) Remove dust bin. Set air path knob
to 'floors'. Use finger to check for
debris (Fig.2).
3) Base hose - Pull down to loosen
end of base hose. Use finger to clear
blockage. Snap hose end back up
into position (Fig.3).
4) Hose connector - Pull out on left
side tab to remove connector.
Remove connector. Remove debris.
Align tab at right and snap connector
back into place (Fig.4).
Hide quick links:
Advertisement
