Electrolux Mightymite - Z4203 Owner's Handbook Manual page 7

NOTE: Always operate the vacuum
cleaner with the motor filter installed,
otherwise reduced suction or motor
damage may result. Do not wash
the motor filter in a washing machine.
Do not use a hairdryer to dry the
motor filter.
8 The micro-exhaust filter needs
to be replaced with a new one
when it gets dirty.
9 Open the air-outlet grille (13)
by pressing the grill latch and
pulling it out. See fig. 19.
10 Take the micro-exhaust filter out
and replace it with a new one.
11 Close the air-outlet grill (13).
GENERAL
TROUBLE SHOOTING
No Power:
If your vacuum cleaner does not
operate check the following:
• The plug connection.
• The electrical wall socket is
switched on.
Loss of suction:
If your vacuum cleaner looses
suction power, check the following:
Fig. 18
• Hose (7) and other accessories
in use are not blocked.
• The filters are clean.
• The dust bag is not full.
Should the above mentioned
checks not solve the problem,
please contact your nearest
Authorised Electrolux Service
Centre for advice.
AUTOMATIC SHUT-OFF
The motor is fitted with a thermal
cut-out switch which will automatically
switch your vacuum cleaner off if it
starts to overheat. If this does
happen the following should be
done.
• Switch the vacuum cleaner off at
the on/off switch and unplug the
mains supply cable.
Fig. 19
• Now leave your vacuum cleaner
in a cool place for approximately
40 minutes to cool down.
• During this time check if the hose,
accessories and filters are
perhaps blocked as this could
have caused the machine to
overheat.
• Once your vacuum cleaner has
cooled down, it will start again. If
it does not restart, contact your
nearest Electrolux Service Center.
7