Table of Contents
Advertisement
access, or slow connection speed. If you really need to add a telephone set
before the splitter, you must add a micro filter before a telephone set. Do not
connect several telephones before the splitter or connect several telephones
with the micro filter.
Step 4. Check the ADSL LED status
Please check the ADSL LED on the front panel. This light indicates the status of
your ADSL broadband through your telephone line. If the light is on, you can
continue setup. However if the light is flashing, there is no broadband line
detected. Please call your Internet Service Provider (ISP) and inform them
about the flashing ADSL light to resolve the issue.
Step 5. Firewall settings
Please turn off all personal firewalls before you continue the setup – firewalls
can block communication between your PC and router.
Note: You must use the power adapter included in the package with the
router, do NOT attempt to use a third-party power adapter.
Step 6:
PC LAN IP configuration
Configure your PC's LAN settings to automatically obtain an IP address from
the router by following the steps below:
Click "Start" and then select "Control Panel".
1.
11
Advertisement
Table of Contents
