Customizing Features / Options-Model Wries30; Recharge; Recharge Scheduled / Tonight; Set Salt Level - Whirlpool WHES20 Installation And Operation Manual

Customizing Features/Options-Model WriES30
Recharge
Recharge button is used to initiate an immediate recharge.
Press and hold the (_) RECHARGE button until the words "RECHARGE", "SERVICE"
and "FILL" flash in the display, and the softener enters the fill cycle of regeneration right
away. The word "RECHARGE" will flash during the regeneration. When over, full water
conditioning capacity is restored.
RECHARGE NOW Initiated
NOTE:
Avoid using hot water while the conditioner is regenerating, because the water heater will
refill with bypass hard water.
Recharge Scheduled
If"you do not want to start all immediate recharge, but would like all extra recharge at the next preset
recharge time, do the folk)wing to schedule a recharge.
• Press and release (do not hold) the _ RECHARGE button. The words "RECHARGE
SCHEDULED" flashes in the display, and the softener will recharge at the next recharge
time. The word "RECHARGE" will flash during the regeneration. When over, full water
conditioning capacity is restored.
Set Salt Level
The water softener has a salt monitor indicator light to remind you to refill the storage tank with salt.
• To set this monitor system, lift the salt hole cover and level the salt in the storage tank.
The salt level decal, on the brinewell inside the tank, has numbers from 0 to 8. Observe
the number the leveled salt is at, or closest to. Now, press the (_) SET SALT LEVEL
button until black ovals corespond to the salt level number. At level 2 or below, the
indicator LED will flash "Check Salt I_vel".
If you want to turn the salt monitor off, press the _ SET SALT LEVEL button until
"SALT LEVEL OFF" shows in display.
!['-! -I
o_
23