Advertisement
9. Select
cycle options
Deep
Delay
Clean
Wash
I
Loud
m
mid
_
mt
_
Soft
EcoBoost
Presoak
Extra
Fabric
Cycle
Rinse
Softener
Signal
Select any other cycle options you may wish to add, if not
previously set. Some cycles will automatically
add certain
options such as Deep Clean or Extra Rinse. These can be
turned off, if desired.
NOTE: Not all options are available with all cycles.
1 0. Press START/PAUSE/UNLOCK
to begin wash cycle
CD
START
Pause/Unlock
Press the START/PAUSE/UNLOCK
button to start the wash
cycle. Filling is delayed for several minutes while load balance
is sensed. When the cycle has finished, the DONE indicator
will light and the end of cycle signal will sound (if set).
Promptly remove garments after cycle has completed to
avoid odor, reduce wrinkling, and rusting of metal hooks,
zippers, and snaps.
Unlocking
the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/PAUSE/UNLOCK;
the lid will unlock once the
washer movement
has stopped. This may take several minutes
if the load was spinning at high speed. Then close lid and
press START/PAUSE/UNLOCK
again to restart the cycle.
If lid is left open for more than 10 minutes the water will
pump out automatically.
Delay
inwater
fill
Filling is delayed for 2 to 3 minutes to check for load unbalance.
You will hear the hum of the spin prior to filling. This is normal
operation.
WASHER
r INTENANCE
r
WATER INLET HOSES
Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Periodically inspect and replace inlet hoses
if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of
replacement
on the label with a permanent marker.
f
CLEANING
YOUR WASHER
Keep your washer as clean and fresh as your clothes.
To keep washer interior odor-free, follow this recommended
cleaning procedure after every 30 washes:
1. Make sure the washer is empty.
2. Using recommended
AFFRESH ® washer cleaner,
add one tablet to washer drum.
OR
If using liquid chlorine bleach, add 1 cup (250 mL)
to liquid chlorine bleach dispenser.
IMPORTANT:
Do not add detergent to CLEAN WASHER
with AFFRESH TM cycle. Do not use more than recommended
amount of bleach to avoid damaging product over time.
3. Close washer lid.
4. Press POWER.
5. Select CLEAN WASHER with AFFRESH TM cycle.
6. Press START/PAUSE/UNLOCK.
NOTE: For best results, do not interrupt cycle. If cycle must
be interrupted,
press Power and run a RINSE & SPIN cycle
to ensure cleaner or bleach have been rinsed from washer.
To clean exterior:
1. Use a soft, damp cloth or sponge to wipe up any spills.
2. Use all-purpose
surface cleaner, if needed.
IMPORTANT: To avoid damaging the washer's finish,
do not use abrasive products.
Page 10
Hide quick links:
Advertisement
Chapters
Troubleshooting
