Starting A Function - Whirlpool RBS240PD Use And Care Manual

•
When showing the time of day, the
display will show the hour and minutes.
• When you are using the Minute Timer,
the display will show hours, minutes, and
seconds in the following sequence:
- For settings from 1-59 minutes, the
display will count down each second
(minutes and seconds displayed).
-For settings 1 hour or over, the display
will count down each minute (hours and
minutes displayed).
• When you are using Cook Time and/or
_ _ Stop Time, the display
will show cooking time
counting down.
-For settings from 1-59 minutes, the
display will count down each second
(minutes and seconds displayed).
- For settings 1 hour or over, the display
will count down each minute (hours and
minutes displayed).
Command pads
The command pads tell the oven what to
do and in what order. Some command pads
have an Indicator Light. The Indicator Light
comes on when you press the command
pad. The ON Indicator Light comes on
when you press the Start/Enter pad for an
oven function.
Selecting an oven
(double ovens)
To choose the oven you want to use, press
_j_ the Upper Oven or Lower Oven pad.
Using the control lock
The control lock prevents unwanted use of
the oven by disabling most of the control
panel command pads (except CLOCK,
TIMER SET/OFF, and LIGHT).
NOTES:
• Control lock is only available when oven is
not in use or control has not been set.
• Set control lock when cleaning the control
panel to prevent oven from accidentally
turning on.
To lock or deactivate the control panel:
Press and hold the StaMJEnter pad for 5
seconds. A single tone will sound
and "Loc" and PI will appear on
the temperature display. When the
control is locked, "START?" will
appear on the display if you press
any command pad.
To unlock the control panel:
Press and hold the Start/Enter pad for 5
seconds. A single tone will sound
and "Loc" and i_ will disappear
from the temperature display.
Starting a function
After programming a function, you must press
the Start/Enter pad to start the
function. If you do not press the
Start/Enter pad within 5 seconds of
programming, "START?" will show
on the display as a reminder.