Resetting The Terminal; Soft Reset (Warm Boot); Hard Reset (Cold Boot) - Honeywell 7600BG-122-B4EE - Hand Held Products Dolphin 7600 User Manual

Resetting the Terminal

There are two ways to reset the Dolphin terminal: a soft reset and a hard reset.

Soft Reset (Warm Boot)

A soft reset re-boots the terminal without losing RAM data. You would perform a soft reset 1) after
installing software applications that require a reboot, 2) after making changes to certain system settings,
or 3) when the terminal fails to respond.
1. Press and hold Red
decode and scan LEDs flash for approximately three seconds.
2. When the reset is complete, the

Hard Reset (Cold Boot)

A hard reset erases all of the data and applications stored in RAM memory and launches AutoInstall, which
!
re-initializes the terminal.
Hard resets automatically launch a soft reset as part of the boot process.
1. Press and hold Red
decode and scan LEDs light for approximately three seconds.
2. The terminal re-initializes, which re-installs all programs stored in the \IPSM\Autoinstall folder.
Note: Set the time and date after each hard reset to ensure that the system clock is accurate. Tap the date on the
Today Screen
Dolphin® 7600 Mobile Computer
User's Guide
Downloaded from www.Manualslib.com
+ ESC
Today Screen
+ TAB
(see page 2-2) to open the Clock setting and set the time and date.
manuals search engine
for approximately 5 seconds. The screen turns white and the
(see page 2-2) appears.
for approximately 5 seconds. The screen turns white and the
Rev A
5/23/2008
3 - 25