Setting Up The Refrigerator; Removing The Refrigerator Doors - Samsung RF197 Series User Manual

Sort up your Fr r Door Aefrg rator
SETTING UP THE REFRIGERATOR
Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and
functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
1. Place the Refrigerator in an appropriate location with reasonable clearance between it and the wall.
Refer to installation instructions in this manual. (page 9, selecting the best location for the Refrigerator)
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly
chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can
store food and drinks in the Refrigerator after the temperature is sufficiently cool.
®
Check the accessories listed below.
Compression fitting
@
Compression nut
L
Hex Wrench Fastener
Required Tools (Not provided)
Phillips screwdriver(+) Flat-blade screwdriver(-)
Socket Wrench
(10mm) (for bolts)
Hex Wrench (3/16")
(for Mid hinge)
Pliers
REMOVING THE REFRIGERATOR DOORS
Some installations require door/drawer removal to transport the Refrigerator to its final location.
Do not remove the door/drawer if it is not needed. Before removing the door/drawer make sure you read
following items.
A
WARNING
®
Disconnect power to the Refrigerator before removing the door or drawer.
o
o
o
Be careful not to drop, damage or scratch the door/drawer while removing them.
Be careful not to get injured while removing the door/drawer.
Reattach the door/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
10 setti]g up