Turning On and Off
Connect the AC cord to power the LCD TV. At this time the TV will enter standby mode and power indicator will turn red.
Use Power button (_) on the top panel of TV or on the remote control to turn on the TV. After switching
off the TV for 5 seconds,
you can turn on TV again.
Choosing TV Channel
Tuning To Analog Channels
An analog channel has a channel number beginning with "A". Input the digital number with numeric buttons directly and press
ENTER button to confirm.
For example, to watch analog channel "A51 ", press "5", "1 ", "ENTER" on remote control in sequence.
Note: Although there is no analog 7q/ signal available in America, we reserve ATe! functions for some expansible use.
Tuning To Digital Channels
A digital channel has a channel number beginning with "D". Input the main digital number with numeric buttons directly, then press
button on remote control, and input the sub number at last.
For example, to watch analog channel "D31-1 ", press "3", "1 ", .....
, "1 ", "ENTER" on remote control in sequence.
You can use CH,", button to increase channel number and CHv
to decrease channel number. When no OSD (On Screen
Display) is used, the up/down
arrows can also work as CH,",/CHv
Selecting Input Source
Press INPUT button on remote control to display Source Select list.
arrows to highlight the source you need and press ENTER to confirm.
Adjusting TV Stand Angle
The TV cabinet can lean forward 5 degrees and backward
15 degrees from the TV table stand.
You can adjust the leaning angle for the best viewing effect and comfort.