Specifications; Maintenance; Troubleshooting - Advent PSS100 - Standard Rear Only System Installation Manual

Specifications

Power Supply
Current Draw
Detecting Distance
Sensor Cable Length
Operating Temperature Range

Maintenance

Though your backup system requires minimum care, you should maintain its
condition and performance using the following the guidelines:
•
Keep the control box away from moisture, extreme heat or cold.
•
Keep the sensors free from snow, ice, and debris.
Diagnostics / Trouble Shooting
Problem
No sound when reverse gear is
engaged.
1 Beep
2 Beeps
3 Beeps
4 Beeps
System beeping without
obstacle behind vehicle
DC9V-DC16V
<120mA
0ft – 5ft
19.68ft
-0°F ~ 176°F
1. Check if ignition/reverse light on
2. Check power cable connection
3. Check switch on speaker
System is functioning correctly
1 sensor is disconnected/damaged
2-3 Sensors are disconnected/damaged
No sensors are connected
1. Ensure sensor is mounted upright.
2. Remove anything mounted on the
vehicle that may be in the detection
area.
3. Verify sensor is installed at the
correct height.
4. Verify sensor is in the correct position
5. Check all connections.
6. Ensure module is not mounted near
electrical components with high
current.
7. Verify supporter was used, if required
(angled/metal bumpers).
10
Solution