Table of Contents
Advertisement
PIP TROUBLESHOOTI
NG
The PIP feature
on this TV only works if you connect a second
video source (like a VCR or satellite
receiver), to your TV with
audio/video
cables. If you use a cable box, you may need extra
equipment.
Refer to page 52 for more information.
Swap won't
work? Make sure the remote is in the right mode.
For example,
once you turn on the VCR with the VCR1 button,
you can't SWAP the pictures until you put the remote
in TV
mode. Just press the TV button.
No signal or bad reception?
Most VCRs and satellite
receivers
have an antenna or TV/VCR button,
Press the antenna
or TV/
VCR button
on the front of the component,
Note: If you programmed
the Universal remote control
to operate
your VCR, the ANTENNA button
on the remote acts as a TV/VCR
button,
Every time you change channels, the same channel appears in
both windows
(the main picture and the PIP picture).
A,
Press the CH CRL button
on the remote until theTV
picture
channel number
is highlighted,
The channel buttons on your
remote control
won't
work correctly for PIP when the VlD channel is
highlighted,
B.
The only way to successfully change channels for the picture,
that is coming from the channel on your VCR (the VlD channel),
is to press
the channel buttons on the VCR or on the VCR's remote control.
CARE AND
CLEANING
CAUTION: Turn OFF your TV before
cleaning.
You can clean the TV as required,
using a soft lint-free
cloth.
Be sure to occasionally
dust the ventilation
slots in the
cabinet
to help assure adequate
ventilation.
The TV's screen may be cleaned
with a soft, lint-free
cloth as
well.
Take care not to scratch or mar the screen. If necessary,
you may use a cloth dampened
with warm
water.
Never
use strong cleaning
agents,
such as ammonia-based
cleaners,
or abrasive
powder.
These types of cleaners
will
damage
the TV.
While cleaning
do not spray liquid directly
on the screen, or
allow
liquid to run down
the screen and inside the TV. Also,
avoid placing
drinks or vases with
water
on top of the TV.
This could increase
the risk of fire, shock hazard or damage
to the TV.
FROM CABLE,
CABLE
BOX, OR ANTENNA
VCR 1
TV
_NFROM ANT CH3
OOT
o 4
A ,o
e,
I
You must use audiolvideo
cables to
connect
your VCR to your TV in order
for
PIP to work.
This example
shows
the connection
for
VID1 (the VCR is connected
to the INPUT 1
connection.)
If you want
to use VlD2,
connect
the VCR to the INPUT 2 connection
on the back of your
TV.
(VlD1) is
from
the
VCR
To change the PIP channel,
press the channel
buttons
on the VCR. To change the TV
channel,
press CH CTRL until
the TV channel
is highlighted
(yellow)
and press the CH up
and down
button
on the remote
control.
56
Advertisement
Table of Contents
Troubleshooting
