Advertisement
Available languages
Available languages
Beverage
Options
The following
beverage containers
will fit in the main
unit of your SkyBox
TM
personal beverage vendor.
12-ounce aluminum
beverage cans
12-ounce glass beverage bottles
12-ounce plastic beer bottles
20-ounce
plastic water and soda bottles
Each storage bin within the main unit is equipped to
dispense bottles or cans.
Highly
Carbonated
Beverages:
Stock lower storage
bins with highly carbonated
beverages and make sure
they are chilled before dispensing.
To avoid overflow
spills when experimenting
with new, highly carbonated
beverages, wait 10-15 seconds before opening
dispensed beverage containers,
and open carefully
over the sink
Capacity:
The top storage bin will hold 10 cans or
5 bottles. The bottom 3 storage bins will each hold 18
cans or 9 bottles.
Important
Steps
For Loading
Please follow loading instructions,
improper
loading
may cause the "low-indicator
light" above the beverage
buttons to ilhminate
prematurely.
1. Make sure the main unit is OFF and the power
cord is unplugged.
2. Open the front door to the main unit, exposing the
four storage bins.
3. When loading the beverage containers,
be sure to
load with the TOPS TOWARD
"[HE FRONT
(i.e. long-neck
bottles with necks towards the
fronO.
UMPORTANT
_ Begin loading the left end of the
storage bin, placing one beverage container
on its
side all the way to the back with the top facing
forward. If loading cans, push the first one all the
way to the back and then place one directly in
fronL
Next, move one space to the right and place
another beverage container all the way to the back
If stocking cans, add another directly in fronL (See
illustration
at bottom of page.} Continue until the
storage bin is filled. Repeat with remaining storage
bins.
Once the bins are filled, close the door, plug the
power cord into a grounded
outlet.
Insert corresponding
o
beverage cards into the
beverage selection
buttons by carefully
pulling the bottom edge
of the buttons forward
and up and slipping
in
the cards. The far left button corresponds
to the
top storage bin. The next button to the right
matches the storage bin that is second from the
top, etc.
Page 11
Advertisement
