Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION
INSTRUCTIONS
Explosion Hazard
Keep flammable
materials
and vapors, such as
gasoline,
away from beverage
center.
Failure to do so can result in death, explosion, or fire.
To ensure proper ventilation for your beverage center, allow for a
1/4" (6.35 mm) space on each side and at the top. When installing
your beverage center next to a fixed wall, leave 21/2 '' (6.35 cm)
minimum clearance on the hinge side to allow for the door to
swing open.
NOTE: It is recommended
that you do not install the beverage
center near an oven, radiator, or other heat source. Do not install
in a location where the temperature will fall below 55°F (13°C). For
best performance,
do not install the beverage center behind a
cabinet door or block the base grille.
I11
It
1/4'i (625 ram)
....
'l' i j L!-
21/2" (6.35 cm)
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow these instructions can result in death,
fire, or electrical
shock.
Before you move your beverage center into its final location, it is
important to make sure you have the proper electrical
connection.
Recommended
grounding
method
A 115 Volt, 60 Hz., AC only, 15- or 20-amp fused, grounded
electrical supply is required. It is recommended
that a separate
circuit serving only your beverage center be provided. Use an
outlet that cannot be turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, unplug beverage center or disconnect
power.
Excessive Weight Hazard
Use two or more people to move and install
beverage
center.
Failure to do so can result in back or other injury.
Remove the Packaging
•
Remove tape and glue residue from surfaces before turning
on the beverage center. Rub a small amount of liquid dish
soap over the adhesive with your fingers. Wipe with warm
water and dry.
•
Do not use sharp instruments,
rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your beverage center.
For more information, see "Beverage Center Safety."
•
Dispose of/recycle all packaging materials.
Advertisement
Table of Contents
