INSTALLATION
INSTRUCTIONS
15
Connecting
the
drain
line
Secure the drain hose in place to prevent moving and leaking.
,--@NOTE
, The drain hose should be properly secured. Failure to
properly secure the drain hose can result in flooding
and malfunction.
, Total height of the house end should not exceed 96
inches (244.8 cm) from the bottom of the washer.
o The drain must be installed in accordance with any
applicable local codes and regulations.
Make sure that the water lines are not stretched
pinched, crushed, or kinked.
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10 cm) from the
end of the drain hose. If the drain hose is extended more than
4 inches (10 cm) beyond the end of the elbow bracket, mold,
or microorganisms could spread to the inside of the washer.
No
more
than
4- inches
(10
cm)
2
Hang the end of the drain hose over the side of the laundry tub.
1
Insert the end of the drain hose into the standpipe.
Drain Hose
Drain Hose
Use a tie strap to secure the drain hose in place.
2
Use a tie strap to secure the drain hose in place.
Cable
Tie
39 t_
(99cm)
(99ca)
Cable
TJe