Advertisement
• Normal
Tap without
thread
& screw
type
inlet
hose
1. Unscrew the fixing screw to
attach the tap.
Upper
Connector
Rubber
Fixing screw
2. Push the connector up till the
rubber packing is in tight contact
with the tap. Then tighten the 4
screws.
Rubber packing
Upper Connector - --. '_,/
_--
3. Push the water supply hose
vertically upwards so that the
rubber packing within in the
hose can adhere completely to
the tap and then tighten it by
screwing it to the right.
Upper
ff:_ _
Connector
_
Plate _-'_
Water supply hose _:_
"_
• Normal
Tap without
thread
& one touch
type
inlet
hose
1. Untighten the upper connector
screw.
2. Push the upper connector up till
3o Connect the water supply hose to
the rubber packing is in tight
the middle connector, pushing
contact with the tap. Then tighten
the plate down.
Upper
Rubber
the 4 screws.
Conn_
packing
/
_connector
Rubber pac_ng_
_:_g_A,, _&--
Upper i1,_
p
late
Fixing Je"_
Middle
Upper Conn_
___fi
Connector
Mid__
Water supply
....
• In case the diameter of the tap
connector_E_
hose
is large remove the guide plate.
Guide _e
_ctor
Used the horizontal tap
• Turn the middle connector not
to have water leaked.
• Make sure that the rubber seal
is inside the hose connector.
Hose conn,@
bber seal
• To separate the water supply
hose from the middle connector
shut off the tap. Then pull the
inlet hose down, pushing the
plate down.
• Your machine comes with only
cold water connection.
• Make sure that there are no
kinks in the hose and that it is
not crushed.
Advertisement
