Table of Contents
Advertisement
Attaching"Z" Fitting
3.
Hold the cable end near the left side of the upper handle
and hook the "Z" end of the brake cable into the blade
control handle from the inside to outside. See Figure 7A.
SecuringBrake Cable
,_
WARNING:
The cable must be routed
properly to avoid contact with all sharp edges
and hot surfaces. Such contacts damage the
cable and render the controls inoperative.
4.
Secure the cable to the lower left handle near the base of
the unit with a cable tie from group 3 of the hardware pack.
Trim off extra length of the cable tie. See Figure 7B.
£tta@i
Wheels
1.
Block the mower securely.
2.
Place the larger two wheels on the rear pivot arm axles
and secure with the flanged lock nuts from group 4 of the
hardware pack.See Figure 8.
3.
Repeat with the two smaller wheels on the front pivot arm
axles.
4.
Remove blocks and put the mower on ground.
Atta@i 8 8h t® Beflscter
1.
Align the holes on the chute deflector with the
corresponding holes on the deck.
2.
Using group 5 from hardware pack, secure with self
tapping screws and bell washers from underside of the
deck and up through the chute deflector. See Figure 9.
£tta@i 8 Starter
1.
Loosely attach the rope guide (from group 6 of the
hardware pack) to the upper handle and thread the handle
knob (also in group 6) only a few turns. Do not tighten.
Make sure that the rope guide is to the outside of the upper
handle. See Figure 10.
2.
The starter rope is attached to the engine. With the spark
plug wire disconnected and grounded, depress the blade
control handle and pull the rope out of the engine.
3.
Slip the rope through the rope guide as shown in Figure
10. Tighten the handle knob holding the rope guide to the
upper handle.
A
B
Lower
Handle
_Catle
Figure 7
Rear Wheel
Pivot
Starter
Rope
Rope
Guide
Fig
10
Knob
\
Advertisement
Table of Contents
