Replacing The Optical Drive - Dell Studio Slim Service Manual

Service manual
Table of Contents

Advertisement

6. Fix the four shoulder screws to the hard drive.
 
7. Connect the power and data cables to the hard drive.
 
8. Connect the power and data cables to the system board.
 
9. Align the shoulder screws on the hard drive with the slots in the hard drive bay and place the hard drive into the hard drive bay.
 
10. Slide the hard drive into the hard drive bay, till it snaps into place.
 
11. Ensure that all the cables are properly connected and firmly seated.
 
12. Replace the computer cover (see
 
13. Connect your computer and devices to electrical outlets, and then turn them on.
 Replacing the Optical Drive
 
1. Follow the procedures in
Before You
 
2. Remove the computer cover (see
 
3. Remove the front panel (see
1
optical drive
 
4. Disconnect the power cable and the data cable from the back of the optical drive.
NOTE:
If you are uninstalling the only optical drive in your computer and will not replace it at this time, disconnect the data cable from the system
board and set it aside.
 
5. Pull the lever gently to release the optical drive.
 
6. Push and slide the optical drive out through the front of the computer.
 
7. To replace the optical drive, fix the four shoulder screws on the optical drive.
Replacing the Computer
Cover).
Begin.
Replacing the Computer
Cover).
Replacing the Front
Panel).
2
lever

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Studio hybrid studio slim540s - studio slim desktop pc

Table of Contents