Assembling Your Bowl Lift Mixer - KitchenAid KP26M1XCE5 Instructions And Recipes Manual

Assembling Your Bowl Lift Mixer
To Attach Bowl
1. Be sure speed control is OFF and
Stand Mixer is unplugged.
2. Place bowl lift handle in down
position.
3. Fit bowl supports over locating pins.
4. Press down on back of bowl until
bowl pin snaps into spring latch.
5. Raise bowl before mixing.
6. Plug into a grounded 3 prong
outlet.
3. Turn beater to left, hooking beater
over the pin on shaft.
4. Plug into a grounded 3 prong
outlet.
Raise
To Remove Flat Beater,
Wire Whip, or PowerKnead
TM
Spiral Dough Hook
1. Slide speed control to OFF and
unplug.
2. Press beater upward and turn
right.
3. Pull beater from beater shaft.
To Raise Bowl
1. Rotate handle to straighbup
position.
2. Bowl must always be in raised,
locked position when mixing.
To Lower Bowl
1. Rotate handle back and down.
To Remove Bowl
1. Be sure speed control is OFF and
Stand Mixer is unplugged.
2. Place bowl lift handle in down
position
3. Remove flat beater, wire whip, or
spiral dough hook.
4. Grasp bowl handle and lift straight
up and off locating pins.
To Attach Flat Beater,
Wire Whip, or PowerKnead
TM
Spiral Dough Hook
1. Slide speed control to OFF and
unplug.
2. Slip flat beater on beater shaft.
Household Stand Mixer
Speed Control
Plug into a grounded 3 prong outlet.
Speed control lever should always be
set on lowest speed for starting, then
gradually moved to desired higher
speed to avoid splashing ingredients
out of bowl. See page 11 for Speed
Control Guide.
Auto-Reset Motor Protection
If the Stand Mixer stops due to
overload, slide the speed control lever
to OFF. After a few minutes, the
stand mixer will automatically reset.
Slide the Speed Control Lever to the
desired speed and continue mixing.
If the unit does not restart, see
"Troubleshooting Problems" on
page 5.