Table of Contents
Advertisement
Common
washing
problems (co.t.)
Problem...
- Cause...
Solution...
Washer makes noise
• Gears engaging after drain and
• This is normal.
(cont.)
before spin.
• Upper part of agitator clicks during wash,
• This is normal.
Won't fill/rinse/
agitate or wrong
temperature
Washer stops
• Power cord not plugged in.
• Timer dial is not lined up.
• Water inlet valve screens arc plugged.
• Water is turned off.
• Plug in power cord.
• Turn timer knob to the right
slightly and pull to start.
• Clean screens.
• Turn on water.
• Hot and cold hoses are reversed.
• Reverse hoses.
• Inlet hose is kinked.
• Straighten hoses.
• Power cord not plugged in.
• No power at plug.
• Plug in power cord.
• Check electrical source or call
electrician.
• Fuse blown or circuit breaker open.
• Replace fuse or reset circuit
breaker. If problem continues,
call electrician.
• Using an extension cord.
• Timer dial is not lined up.
• Do not use extension cords.
• Turn timer to the right slightly
and pull to start.
• Set and pull out knob.
• Allow cycle to continue.
• Timer knob not pulled out.
• Washer at pause in Permanent Press
cycle (approximately 2 minutes).
• Machine is overloaded.
• Wash smaller loads,
Agitator operation
• The top of the agitator moves only in one
• This is normal.
direction.
• The top of the agitator is loose.
• This is normal.
Water level seems
• The top of the agitator is much higher
• This is normal.
too low or washer
than the highest water level. This creates
"
not completely filling
a perception of the washer not being full.
Washer tub is
• Tub is pulled forward when unloading.
• Push tub to center before
crooked
starting.
• This is normal.
• Tub moves.
• Unit not level.
• Ensure front feet are installed
and nuts tightened. Level
washer. Reset rear leveling legs.
See Installation Instructions.
Advertisement
Table of Contents
