KitchenAid KSF26C4XYY01 User Instructions page 10

Hide thumbs

Advertisement

1. Remove theProduce Preserver pouch f rom itspackaging.
IrFreshFlow
produce
preserver
CAUTION
ATTENTION
IRRITANT
IRRITANT
Read cautions
on back
Life les mises
en garde
au dos.
2. Lift up on the housing in order to remove it from its mounting
tab along the wall.
3. Open the housing by pulling up and out on the back of the top
of the housing.
4. Place the pouch inside the housing, then snap the housing
back together.
5. Place the housing back on the mounting tab along the wall.
Installing the Status Indicator (on some models)
The Produce Preserver comes with a status indicator, which
should be activated and installed at the same time the pouch is
installed.
REFRIGERATOR
USE
The refrigerator
and freezer c ontrols arelocated on thedispenser
panel.
IMPORTANT:
The display screenon thedispensercontrol panel
will t urnoffautomatically and enter "sleep" mode when the
control buttonsand dispenserlevers have notbeen used for
2 minutesor more. While in"sleep" mode, thefirst pressofa
control buttonwill o nlyreactivate thedisplay screen, without
changingany settings. After reactivation,
changes to any settings
can thenbe made. If no changes aremade within 2 minutes, the
display will re-enter "sleep" mode.
Touch any control button on the dispenser panel to activate
the display screen. The home screen will appear as shown.
1. Place the indicator face-down
on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator, until
the bubble pops to activate the indicator.
3. Slide open the cap on the Produce Preserver housing.
4. Place the indicator in the top of the housing, facing outward.
5. Slide the cap closed, and check that the indicator is visible
through the rectangular hole in the cap.
NOTE: The cap will not easily close if the indicator's rear
bubble has not been popped.
Replacing
the Produce
Preserver
The disposable pouch should be replaced every 6 months, when
the status indicator has completely changed from white to red.
To order a replacement, contact us using the assistance/service
information following the warranty.
1. Remove the old pouch from the Produce Preserver housing.
2. Remove the old status indicator.
3. Install the new pouch and status indicator using the
instructions
in the previous sections.
Adjusting the Controls
For your convenience, your refrigerator and freezer controls are
preset at the factory. When you first install your refrigerator, make
sure that the controls are still set to the "mid-settings."
The factory
recommended
set points are 37°F (3°C) for the refrigerator and
0°F (-18°C) for the freezer.
IMPORTANT:
Wait 24 hours before you put food into the refrigerator. If you
add food before the refrigerator has cooled completely, your
food may spoil.
NOTE: Adjusting the set points to a colder than
recommended
setting will not cool the compartments
any
faster.
If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
The preset settings should be correct for normal household
usage. The controls are set correctly when milk or juice is as
cold as you like and when ice cream is firm.
Wait at least 24 hours between adjustments.
Recheck the
temperatures
before other adjustments are made.
To view and adjust the set points, press and hold the
TEMPERATURE button for 3 seconds. When adjust mode is
activated, adjusting information will appear on the display screen.
10

Hide quick links:

Advertisement

loading

  Related Manuals for KitchenAid KSF26C4XYY01