PAN AND GRID
Do not clean in the Self-Cleaning cycle.
Mildly abrasive cleanser:
Scrub with wet scouring pad.
Solution of 1/2cup (125 mL) ammonia to 1 gallon (3.75 L)
Soak for 20 minutes, then scrub with scouring or steel wool
Follow product label instructions.
Porcelain enamel only, not chrome
Plastic scouring pad
The oven lights are 12 volt, 5-watt maximum halogen bulbs. They
will come on when the oven door is opened. They will not work
during the Self-Cleaning cycle. When the oven door is closed,
press OVEN LIGHT to turn them on or off.
Before replacing, make sure the oven is off and cool.
Remove glass light cover by grasping the front edge and
pulling away from oven.
There is no need to remove the oven door for normal use.
However, it can be done if necessary.
Before removing or replacing, make sure all controls are off and
the oven is cool. The oven door is heavy. Use both hands, do not
lift or carry the door by the handle and another person to help is
suggested. Use care not to damage the outer finish.
1. Open the oven door all the way.
2. Insert short end of door removal pins, included with the oven,
into both hinge hangers. Two %2 in. (4 mm) allen wrenches or
two nails of similar diameter can be used if door removal pins
have been misplaced.
Do not remove the pins while the door
1.Insert smafl end of pin here
Grasp under door handle and carefully close door as far as it
will shut. Pull door out from the bottom.
Remove bulb from socket.
Replace bulb, replace bulb cover by snapping back into wall.
1. Make sure door removal pins have not been removed. Fit
hinge arms into slots in frame. Push in at lower corner to
ensure hinge arms are fully engaged.
Open the door completely and remove the door removal pins.
Save them for future use.
Close oven door. If the door does not operate freely, repeat