Download Print this page

Range Hood Care - KitchenAid KXW8730YSS0 Installation Instructions And Use & Care Manual

30" 36" and 48" (76.2 cm, 91.4 cm and 121.9 cm) commercial style wall-mount canopy range hood
Hide thumbs


Table of Contents
a Halogen
Turn off the range hood and allow the halogen lamp to cool. To
avoid damage or decreasing the life of the new bulb, do not
touch bulb with bare fingers. Replace bulb, using tissue or
wearing cotton gloves to handle bulb.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect
2. Push up on the lens and turn it counterclockwise.
3. Remove the bulb and replace it with a 120-volt, 50-watt
maximum halogen bulb with a GU10 base. Turn it clockwise
to lock it into place.
4. Repeat steps 2-3 for the other bulbs if needed.
5. Reconnect power.
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions.
Replace grease filters
before operating hood.
Exterior surfaces:
To avoid damage to the exterior surface,do
not use steel wool or
soap-filled scouring pads. Rub in direction of the grain line to
avoid scratching
the surface.
Always wipe dry to avoid water marks.
Stainless Steel Cleaner and Polish.
Mild liquid detergent and water.
Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
Metal Filters and Drip Trays:
Use 2 hands to remove filters. Grasp filter handles, pull toward
the front of range hood and pull down on the rear handle to
remove. Repeat for each filter.
A. Grease filter
Remove grease drip tray.
A. Drip tray
Wash metal filters and grease trays as needed in dishwasher or
hot detergent solution to clean.
Replace grease drip tray.
Reinstall filters, grasp filter handles and place front edge of filter
into the hood. Push up on the back handle and set rear of filter
into the drip tray to secure. Repeat for each filter.
A. Grease filter


Table of Contents

  Related Manuals for KitchenAid KXW8730YSS0

This manual is also suitable for: