Install Vent Covers; Complete Installation; Range Hood Use - KitchenAid KXW4430YSS0 Installation Instructions And Use & Care Manual

5. Use UL listed wire connectors and connect black wires (C)
together.
6. Use UL listed wire connectors and connect white wires (E)
together.
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire
in terminal box.
Failure to do so can result in death or electrical shock.
7. Connect green (or bare) ground wire from home power supply
to yellow-green ground wire (F) in terminal box using UL listed
wire connectors.
8. Tighten strain relief screw.
9. Install terminal box cover.
10. Check that all light bulbs are secure in their sockets.
11. Reconnect power.
When using both upper and lower vent covers, push lower cover
down onto hood and lift upper cover to ceiling and install with 2 -
4 x 8 mm screws.
NOTE: For vented installations, upper vent cover may be
reversed to hide slots.
C
D
Secure the bottom of the duct with 2 - 4 x 8 mm assembly
screws.
1. For non-vented (recirculating) installations only, install
charcoal filters over grille on blower housing. See the "Range
Hood Care" section.
2. Install metal filters. See the "Range Hood Care" section.
3. Check the operation of the range hood blower and light. See
the "Range Hood Use" section.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The range hood controls are located on the front side of the
canopy. The light switch for the top lights is located on the
underside right of the canopy.
A. Upper vent cover
B. Lower vent cover
C. 4 x 8 mm screws
D. Bracket
E F G H I
A. Louver holes (non-vented
[recirculating] installations only)
B. Duct covers
C. Bottom lamp housings
D. Canopy
E. Grease filters
F. Grease filter handles
G. Light switch - top
H. Top lamp housings
I. Control panel