Water Dispenser & Ice Service - Kenmore ELITE 25374221700 Use & Care Manual

WATER
DISPENSER
Your refrigerator includes an automatic water dispenser on
the front of the refrigerator door. The dispenser is designed
to accommodate containers up to 71/2inches high.
r
Dispensing Water
To operate the water dispenser, hold a drinking glass against
the back of the dispenser under the spout and press the
"Water" button. Hold the glass as far in as possible, ensuring
that the water dispensing spout is inside the lip of the glass.
To stop dispensing water, release the "Water" button and pull
the glass away from the dispenser For colder water, firsl
add ice to your drinking glass.
/
/
Press for water //
\ /
0
I
/
/
/
Water Dispenser
The Filter Reset indicator light above the button will light up
each time the Water button is used. The following filter light
indications are:
Green The filter is still operating within its specified life
cycle.
Amber The filter has reached approximately 80% of its
useful life. This is the recommended time to
purchase a replacement filter.
Red The filter is 100% used up. Change the filter as soon
as possible.
After the filter cartridge has been changed, press and hold
the Filter Reset button for 10-15 seconds.
Dispenser Lock
The water dispenser includes a "Lock" button that allows
you to disable the water dispenser. You can use this lock to
prevent accidental spills, such as those caused by children
pressing the dispensing button without a glass.
To Lock Out Press the LOCKTouch Pad for3-5 seconds.
A Red light will appear above the Touch Pad.
To Unlock Press the LOCK Touch Pad for 3-5 seconds
until the Red light above the Touch Pad goes
out.
Lock button
_'/
qltett*dW_r_
How the Water Dispenser Works
The water tank. located inside the refrigerator door.
automatically fills as water is dispensed For proper
dispenser operation, the recommended supply water
pressure should fall between 30 psi and 100 psi.
Water pressure must not exceed 100
Ibs. Excessive pressure may cause
water filter to malfunction.
After the refrigerator is connected to the water supply, fill
the water tank by drawing one glass of water. It may take
about 11/2minutes after activating the dispenser button
before water begins to fill this first glass. Continue flushing
the system for 3 minutes to rid the tank and plumbing
connections of any impurities.
14