Electronic Oven Controls; Display; Stop; Clock - Kenmore ELITE 66598013700 Use & Care Manual

ELECTRONIC OVEN CONTROLS
A B C D E
,/.
UPPER OVEN
oo8
Bake Broil Clean Warm 9 Zone
Bake Roast Autoset
LOWER OVEN
#
t_o_) 1 2
4 5
0
2 Hold Y
7
/ /
O N M L K J / H
A. Upper oven settings G. Autoset L. Cook & Hold
B. Oven display H. Favorite setting M. Clock
C. Upper oven light L Lower oven stop IV.Timer 2
D. Upper oven stop J. Lower oven light O. Timer 1
E. Number pads K. Delay R Lower oven settings
F. Cooktop surface warmer zone
When power is first supplied to the appliance, a flashing time will
appear on the display. See "Clock" section to set time of day.
If a flashing time appears at any other time, a power failure has
occurred. Press STOP and reset the clock if needed.
When the oven is not in use, the display shows the time of day.
The Stop pad stops any function except the Clock, Timer, and
Control Lock.
To Restore:
Press and hold upper oven STOP and CLOCK for 3 seconds. The
time of day will reappear from the display.
Ran{ 2eLTgh s
Oven Lights
While the oven door is closed, press OVEN LIGHT to turn the
light on and off. The oven light will come on when the oven door
is opened. The oven light will not come on during the Self-Clean
cycle.
The clock can be set to display time in a 12-hour or 24-hour
format. The clock is set at the factory for the 12-hour format.
To change the clock to 24-hour format:
1. Press and hold the upper oven STOP pad and FAVORITE pad
for 3 seconds. "12 Hr" will flash in the display.
2. Press AUTOSET to select '<24 Hr"; press again to select
'<12 Hr."
3. Set the time of day by following the "To Set" instructions.
To Set:
Before setting, make sure the oven and Timer are off.
1. Press CLOCK. The time of day and colon flash in the display.
2. Press the number pads to set the time of day.
3. Press CLOCK again or wait 4 seconds. The colon will remain
on,
To recall the time of day when another time function is showing,
press CLOCK.
To Cancel:
Press and hold upper oven STOP and CLOCK for 3 seconds. The
time of day will disappear from the display.
When the clock display is canceled, press CLOCK to briefly
display the time of day.
Tones are audible signals, indicating the following:
Basic Functions
One tone
• Valid pad press
• Oven is preheating (long tone)
• Function has been entered
Two tones
• Invalid pad press
Four tones
• End of cycle
Adjusting Sound Level
The oven is factory set for medium (MEd) but can be changed to
low (LO) or high (HI).
I. Press and hold DELAY and UPPER STOP for 3 seconds. A
beep will sound. "bEEP" and the current sound level will be
displayed.
2. Press AUTOSET to increase or decrease the sound level.
Wait 4 seconds for the new setting to be accepted.
If AUTOSET is not pressed within 30 seconds, the control will
return to the existing setting.