Rub indirection o fgrain toavoid damaging.
• Stainless Steel Cleaner &Polish ( included):
See back cover f orordering information.
• Liquid detergent orall-purpose cleaner:
Rinse w ithclean water a nddrywithsoft, l int-free c loth.
• Vinegar forhard water s pots.
Do not use steel wool, abrasive powder cleansers, chlorine
bleach, rust remover or ammonia because damage may occur.
Always wipe with a clean, wet cloth and dry thoroughly to avoid
streaking and staining.
Cooktop Cleaning Creme supplied with your cooktop should be
used regularly to help avoid scratches, pitting and abrasions, and
to condition the cooktop.
It can be purchased as a kit along with
the Cooktop Scraper. Ask for stock number 22-364-WX10X117
A blue 3M SCOTCH-BRITE ®no scratch scrub sponge supplied
with your cooktop is also recommended
for stubborn soils. This
pad is designed specifically to keep your radiant glass clean. Do
not use this pad to clean any other surfaces.
A Cooktop Scraper is also recommended
for stubborn soils, and
can be ordered as an accessory. Ask for stock number
0X302 when ordering. The Cooktop Scraper uses
razor blades. Store razor blades out of the reach of children.
Light to moderate
Paper towels or blue 3M SCOTCH-BRITE ® no scratch scrub
sponge: Clean while the cooktop is still warm. You may want
to wear oven mitts while doing so.
Sugary spills (jellies, candy, syrup)
Blue 3M SCOTCH-BRITE ®no scratch scrub sponge: Clean
while the cooktop is still warm. You will want to wear oven
mitts while doing so.
Cooktop Scraper, Cooktop Cleaning Creme and clean damp
paper towel: Clean as soon as cooktop has cooled down.
Rub creme into surface with a damp paper towel or soft
cloth. Continue rubbing until white film disappears.
Heavy soil, dark streaks, specks and discoloration
Cooktop Scraper, Cooktop Cleaning Creme or nonabrasive
cleanser: Rub product into soil with a damp paper towel or
soft cloth. Continue rubbing until white film disappears.
Cooktop Cleaning Creme and blue 3M SCOTCH-BRITE ®no
scratch scrub sponge: Rub creme into soil with damp paper
towel. Repeat for stubborn spots. Polish entire cooktop with
creme and paper towel.
Metal marks from aluminum and copper
Cooktop Cleaning Creme: Clean as soon as cooktop has
cooled down. Rub creme into surface with a damp paper
towel or soft cloth. Continue rubbing until white film
disappears. The marks will not totally disappear but after
many cleanings become less noticeable.
Cooktop Cleaning Creme: Rub creme into surface with a
damp paper towel or soft cloth. Continue rubbing until white
film disappears. Scratches and abrasions do not affect
cooking performance and after many cleanings become less
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate
has flashing lights
Is the cooktop
for more information.
Has a household fuse blown, or has a circuit breaker
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Are there lights on the cooktop
on and off?
1. Make sure the cooktop controls are Off.
2. Clean the cooktop touch control panel thoroughly. See
the "General Cleaning" section.
If the cooktop lights continue to flash, disconnect
or unplug the cooktop.
4. After a few seconds, reconnect power or plug in the
If the lights continue to blink on and off, call for service.
cooking results not what expected
will not operate
Is the cooktop
control set correctly?
Touch ON/OFF before selecting a setting.
On ceramic glass models, is the "All Off Locked" Cooktop
See the "All Off/Locked"
Excessive heat around cookware
Is the cookware the proper size?
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than 1/2"(1.3 cm) outside the cooking area.
Is the proper cookware being used?
See the "Cookware"
Is the cooktop touch control set to the proper heat level?
See the "Cooktop Touch Controls" section.
Is the appliance level?
Level the appliance. See the Installation Instructions.