Advertisement
Available languages
Available languages
Grill Lighting
Instructions
1.Before each use, check all hoses for cracks, nicks, cuts,
burns or abrasions. If a hose is damaged in any way, do not
use your grill before replacing the hose with an authorized
part from the Parts List. Also make sure all gas supply
connections
are securely tightened.
2. Familiarize
yourself
with the safety and Use and Care
instructions
in this guide. Do not smoke while lighting grill
or checking
gas supply connections.
3. Be sure the LP Gas tank is filled.
4.Open the Grill Lid.
Failure to replace a faulty hose, secure gas supply
connections
or to open the Lid before proceeding
to
theLighting Procedures could result in a fire or explosion
that could cause serious bodily injury, death, or property
damage.
5.Set Control Knobs to OFF and open the LP Gas tank valve
SLOWLY 1/4 of a turn.
Rotisserie
Burner
Lighting
Instructions
1. Follow steps 1 through 5 ofthe Grill Lightinglnstructions.
2. Push and turn Control Knob to _ and hold knob in.
3. Keep pressing while you turn knob to HI and hold in
5 - 10 seconds before releasing.
4. If ignition does not occur in 5 seconds, turn gas off at
source and turn Control Knobs OFF. Wait at least 5
minutes for gas to clear, then retry. If your grill still fails
to light turn the Control Knob(s) and gas source OFF.
Wait 5 minutes for gas to clear and then conduct a leak
test as explained in the LP Gas Tank Installation of this
guide. If no leaks are detected,
repeat the lighting
procedure.
5. After Burner is lit, turn the tank valve SLOWLY one
more 1/4 of a turn.
IMPORTANT:
Do not use the Rotisserie Burner and Main
Burners at the same time. Rotisserie burner is for Rotisserie
Cooking only.
MAIN BURNER
ROTISSERIE
INFRARED BURNER
KNOB:
BURNER KNOB:
KNOB:
•
Open
LP Gas tank
[\
6.Push and turn Left Main Burner Control Knob to _r and
hold in. You will hear a clicking
sound from the elec-
trodes
of all burners.
Note: Only the burner you are turning on will ignite. Once
the burner is lit, turn the knob back to HI.
7. If ignition does not occur in 5 seconds, turn gas off at source
and turn Control Knobs OFF. Wait at least 5 minutes for gas
to clear, then retry. If your grill still fails to light, turn the burner
Control Knob(s) and gas source OFF. Wait 5 minutes for gas
to clear and then conduct a leak test of ALL gas connections
and gas sources as explained in the LP Gas Tank Installa-
tion of this guide. If no leaks are detected, repeat the lighting
procedure.
//'
i
Infrared
Burner
Lighting
Instructions
1. Follow steps 1 through 5 of the Grill Lighting
Instructions.
2. Push and turnControI Knob to _, and hold knob in.
3. Keep pressing while you turn knob to Hi and hold in
5 - 10 seconds before releasing.
4. If ignition does not occur in 5 seconds, turn gas off at
source and turn Control Knobs OFF. Wait at least 5
minutes for gas to clear, then retry. If your grill still fails
to light turn the Control Knob(s) and gas source OFF.
Wait 5 minutes for gas to clear and then conduct a leak
test as explained in the LP Gas Tank Installation of
this guide. If no leaks are detected, repeat the lighting
procedure.
5. After Burner is lit, turn the tank valve SLOWLY one
more 1/4 of a turn.
8.After one Burner is lit, turn the tank valve SLOWLY one
more 1/4 of a turn.
9. Turn each other burner knob to _, to light, then back to HI.
Note: When lighting all three main burners, start with the
burner furthest from fuel source location, then light remain-
ing burners in sequence moving toward fuel source.
Burner
Control
Knobs on Control
Panel
/_
Rot sser e
nfrared
Main Burner
Burner
Burner
16
Advertisement
