Logs - Nokia 9000i communicator User Manual

Chapter 3 - Contacts
(number 1 is reserved for calling your voice mail-
box, see chapter 4 "Telephone: Telephone set-
tings" on page 4-6). For information on how to use
the speed dials, see chapter 13 "Phone interface:
Using memory - Dialling shortcuts" on page 13-5.
To set speed dials:
Press Speed dials in an opened contact card.
All phone number fields of the contact card
are shown.
Select a field to which you want to assign a
speed dial and press Change. Select a loca-
tion and press OK.
To change or remove speed dials:
Select the speed dial you want to change or
remove and press Change.
Move the selection frame to the location you
want to use and press OK. If you want to re-
move a speed dial location, choose None.
Storing DTMF tones
The Dual Tone Multi Frequency (DTMF) tones al-
low you to communicate with voice mailboxes,
computerised telephony systems, etc. For infor-
mation on how to send DTMF tones, see chapter
4 "Telephone: Managing calls - Sending DTMF
tones" on page 4-5, or chapter 13 "Phone inter-
face: Sending DTMF tones" on page 13-3.

Logs

The Contacts application shows all communica-
tion events as two logs:
• General log shows all (or certain types of)
communication events in chronological order,
see figure 3-2.
• Individual log shows a list of all communi-
cation events relating to the selected contact.
To access the logs:
Press Logs in the Contacts main view. The
command set changes.
• If you only communicate with the contact
using DTMF tones, create a contact card for
the DTMF contact.
• If you need both a voice and a DTMF phone
number for the contact, add a new field to an
existing contact card. The DTMF sequence can
be stored either in the Tel field, after the tele-
phone number, or separately, in a DTMF field.
If you store the sequence in a Tel field, the
phone number and the DTMF sequence must
be separated by one of the DTMF special char-
acters. Label the field (with Change label) so
you can identify the DTMF sequence.
The DTMF special characters are listed in the
following table:
Character Function
May be used if the DTMF
* and #
service requires them.
Inserts a pause of 2.5 sec-
p (pause) onds in front of, or between,
DTMF digits.
When the "w" character is
stored in a sequence, the
rest of the sequence is not
w (wait)
sent until you press Send
again in the Telephone
application.
Table 3-1
Select the desired log type by pressing either
Individual log or General log.
To erase the contents of the log:
Press Clear list. A pop-up box opens to let you
define which contacts will be deleted (meas-
ured in days). The clearing procedure reflects
on the other log, as well.
To create a new contact card:
Open the General log.
1998 Nokia Mobile Phones. All Rights Reserved.
3-3