Initializing The Unit; Cleaning The Unit; Enabling Cleaning Mode - Panasonic KX-UT670 Operating Instructions Manual

Miscellaneous Information

Initializing the Unit

Initializing the unit resets all its settings to their factory
default values. For details, consult your administrator or
dealer.
120 Operating Instructions

Cleaning the Unit

When you clean the unit, turn off the unit by unplugging
the AC adaptor and/or disconnecting the Ethernet
cable. Cleaning the unit while it is still on can result in
erroneous behavior.
However, by enabling cleaning mode, you can wipe the
display without turning the unit off (Page 120).
•
Wipe the unit with a soft and dry cloth.
If the unit becomes particularly dirty, apply a light
kitchen cleanser to a soft cloth, wring the cloth
thoroughly, and then wipe the unit. When finished,
dry the unit with a soft and dry cloth.
•
Do not clean the unit with cleaners that contain:
petroleum, scouring powder, paint thinner,
benzene, wax, hot water or powdered soap. When
using chemical cleansers, follow the instructions on
the label carefully.
•
When wiping smudges off the display, use a soft
and dry cloth. Touch the display only with the fleshy
part of your fingers, and avoid touching it with your
fingernails.

Enabling Cleaning Mode

To prevent incorrect operation while cleaning the unit,
you can set the unit to ignore any operations from the
key sheet and the display.
1.
On the Home screen, press
2.
Tap [Settings].
3.
Tap [Touch panel].
4.
Tap [Cleaning mode].
Note
•
This mode can be enabled only when the unit is
idle.
.
Document Version 2011-09