Download  Print this page

Undercounter Installation - KitchenAid KUCV151MSS0 Use & Care Manual

Hide thumbs

Advertisement

NOTE: Proper installation is your responsibility.
Make sure you
have everything necessary for correct installation. It is the
personal responsibility
and obligation of the customer to contact
a qualified installer to assure that electrical installation meets al(
National and Local codes and ordinances.
Tools and materials needed for installation:
Level
Tape Measure
Pliers
Scissors
Phillips No. 2 Screwdriver
Flat-Head Screwdriver
%6 in. Hex-Head Socket Wrench
Utility Knife
IMPORTANT:
Do not grasp control panel to move compactor.
Slide compactor
onto cardboard or hardboard before moving
compactor
across floor to prevent damaging floor covering.
Do not allow the rear frame of the compactor
to touch the
floor covering when lifting or moving compactor.
Undercounter
installation
NOTE: Installation hardware is not provided with full cabinet
models.
1. Measure the height of your cabinet opening. The top of the
compactor
should be at least 1/8in. (3 mm) from the top of the
cabinet opening.
The rear wheels are preset for a cabinet opening height of
341/4 in. (87 cm) (position "A").
To adjust for other cabinet opening heights:
Loosen self-tapping
screw just enough to clear stud from
hole in position "A."
Move the rear wheel and stud to position "B" or "C" as
needed for your cabinet opening measurement:
Position B: 341/4in. to 347/16in. (87 to 87.5 cm)
Position C: 347/16in. to 34% in. (87.5 to 88 cm)
NOTE: To level the unit in position "C," you may need to
add shims under the leveling legs.
Tighten screw. Repeat for other rear wheel.
2.
Use pliers to lower leveling legs away from cabinet. Adjust
legs so there will be a I/8 in. (3 mm) to 1/4in. (6.4 mm) space
between the top of the compactor
and the top of the cabinet
opening. Stand the compactor
upright.
3.
For model with cabinet, remove the plastic plugs from the
compactor
cabinet top.
4.
Move the compactor
close to its final position.
5.
Plug into a grounded 3 prong outlet.
6.
Determine if you want the compactor
frame or drawer front
flush with the cabinet front.
Using the two #8-18 x 5/16 in. screws, install the retaining
brackets to cabinet top as needed:
If the compactor
frame is to be flush with the cabinet
front, place retaining bracket screws through "A."
If the compactor
drawer front is to be flush with the
cabinet front, place retaining bracket screws through "C."
If the compactor
is to be midway between "A" and "C,"
place the retaining bracket screws through "B."
.---J'"'-.
1
!. Countertop
2. Retaining bracket
7. Carefully lift the front slightly and roll compactor
into the
cabinet opening.
Using the two #8-18 x I/2 in. screws, fasten the retaining
brackets to the countertop
with the mounting screws.
If brackets cannot be attached to the underside of
countertop,
attach mounting clips to brackets. Fasten
compactor
to cabinet front with mounting screws through
mounting clips.
Countertop
mounting
4
1. Wheel bracket assembly
2. Cabinet
3. Locating stud
4. Self-tapping
screw (pivot)
!. Countertop
2. Retaining bracket
3. Mounting screw

Advertisement

Table of Contents
loading

  Related Manuals for KitchenAid KUCV151MSS0

This manual is also suitable for:

Kucv151mmt0Kucc151lss0Kucc151lpa0