Cooktop Controls - KitchenAid KDRU707 Use & Care Manual

7. Once the self-clean setup function is complete, the Start key
will light up.
8. When settings are correct, touch START.
9. Once the Start key is touched, the Delayed Self-Clean will be
displayed showing the settings. A countdown timer will be
displayed in the lower left hand portion of the display
showing the time remaining until self-cleaning begins.
10. When the start time is reached, the oven will automatically
turn on. The countdown timer will appear on the oven display.
If the door is opened before the self-clean cycle begins, the
self-clean cycle will be canceled and a message will appear.
Touch OK to return to the Main Menu.
11. When the end of the self-clean time is reached, the oven will
shut off automatically and the Complete message will be
displayed. If enabled, end-of-cycle tones will sound, then
reminder tones will sound every minute. Touch OK to clear
this message, stop reminder tones and return to the Main
Menu
Once the self-clean cycle starts, the door will automatically lock
and "DOOR LOCKED" will appear on the display.
The door will not unlock until the oven cools and the Complete
message appears.
To Stop Self-Clean anytime:
Touch OFF. If the oven temperature is too high, the door will
remain locked. It will not unlock until the oven cools.
Water filter cartridge should be replaced when "REPLACE
FILTER" appears in the control panel display, or after 1 year of
use.
For further information or to order a replacement water filter
cartridge, visit www.whirlpool.com or call 1-866-986-3223. Ask
for Part Number 8212695.
To Replace Water Filter:
Turn filter cartridge to the left to remove cartridge from the filter
head.
Install new cartridge. Turn cartridge to the right to reattach to the
filter head.
A. Filter head
B. Filter cartridge
If you need Assistance or Service:
Please reference the "Assistance or Service" section.
IMPORTANT: Before cleaning, make sure all controls are off and
the oven is cool. Always follow label instructions on cleaning
products.
Soap, water and a soft cloth or sponge are suggested first unless
otherwise noted.
STAINLESS STEEL (on some models)
Do not use soap-filled scouring pads, abrasive cleaners, Cooktop
Polishing Creme, steel-wool pads, gritty washcloths or abrasive
paper towels. Damage may occur, even with one-time or limited
use.
Rub in direction of grain to avoid damaging.
Cleaning Method:
• KitchenAid _ Stainless Steel Cleaner and Polish Part Number
4396920 (not included) or KitchenAid _ Stainless Steel Wipes
Part Number 8212510 (not included):
See "Assistance or Service" section to order.
• Liquid detergent or all-purpose cleaner:
Rinse with clean water and dry with soft, lint-free cloth.
PORCELAIN-COATED GRATES AND CAPS
Food spills containing acids, such as vinegar and tomato, should
be cleaned as soon as the cooktop, grates and caps are cool.
These spills may affect the finish.
To avoid chipping, do not bang grates and caps against each
other or hard surfaces such as cast iron cookware.
Do not reassemble caps on burners while wet.
Do not clean in the Self-Cleaning cycle.
Do not clean in dishwasher.
Cleaning Method:
• Nonabrasive nylon scrub pad and mildly abrasive cleanser:
Clean as soon as cooktop, grates and caps are cool.
SURFACE BURNERS
Sealed Burner models
See "Sealed Surface Burners" section.
COOKTOP CONTROLS
To avoid damage to the cooktop controls, do not use steel wool,
abrasive cleansers or oven cleaner.
To avoid damage, do not soak knobs.
When replacing knobs, make sure knobs are in the Off position.
Do not remove seals under knobs.
NOTE: When replacing knobs after cleaning either the surface
burner controls or the griddle module control, make sure the
knobs are replaced to the correct location. The 20,000 Btu/h
burner knobs have power settings and the griddle knob has
temperature settings. All other knobs have Hi, Med, Lo settings
only.
Cleaning Method:
• Warm, soapy water:
Pull knobs straight away from control panel to remove.
38